E 250 Van V8-6.9L DSL (1985)
Flex Plate: All Technical Service Bulletins
Starter Motor/Ring Gear - Excessive Wear
Article No. 85-10-21
STARTER MOTOR - RING GEAR - EXCESSIVE WEAR - (6.9L)
LIGHT TRUCK 1983-85 E & F SERIES
CALIBRATION: 6.9L ONLY
Subject vehicles which have experienced repeated milling of the ring gear should have the existing starter motor replaced with the newly released starter
(E5TZ- 11002-B), supplied by Mitsubishi, which has improved length of drive gear engagement. Simply replacing the drive gear on the existing starter
motor will not cure the milling concern. Additionally, when installing the new starter, the ring gear must also be replaced (Part No. E3TZ-6384-A), in
accordance with the instructions outlined in Section 22-08-30 of the 1985 Truck Shop Manual (Volume B, Engine).
After replacing the starter assembly, two (2) nut/ washer assemblies will be required to secure the electrical cables to the starter motor assembly. (See
parts list).
PART NUMBER
PART NAME
CLASS
E5TZ-11002-B
Starter Motor Assy.
R
E3TZ-6384-A
Ring Gear
A
N802775-S36
Nut-Washer Assy.
S
(M5 x .80)
N802776-S36
Nut-Washer Assy.
S
(M10 x 1.5)
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP6384A85
TIME:
F Series
Econoline
4x2 ................ T19
3.3
-
4x2 ................. C6
3.1
3.1
4x4 ................ T19
4.2
-
4x4 ................. C6
4.2
-
OPERATION: SP6384A185
TIME:
Extra time if equipped with
coupling shaft
0.2
0.2
OPERATION: SP6384A285
TIME:
Extra time if equipped with
full floor carpet
0.5
-
OPERATION: SP6384A385
TIME:
Extra time if equipped with
skid plate
0.2
-
DLR CODING:
Basic Part No. 11350 - Code: 30