E 250 Van V8-6.9L DSL (1985)
![background image](/ford/e_250_van/v8-6.9l_dsl/Page-426002.png)
3.
Connect a jumper lead to the terminal, Figure 14.
4.
Turn ignition switch to "Run" position.
5.
Energize fuel pump, by grounding jumper lead from self-test connector, and check fuel pressure. If there is no pressure, be sure pump is receiving
power. If necessary, correct any circuit fault.
CAUTION: Only ground to fuel pump terminal, or damage may occur to the EEC IV processor.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: "INFORMATION ONLY"