E 350 V10-6.8L (2007)
Front Brake Components - Dual Rear Wheel (Part 2)
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Release the speed sensor wiring from the front brake hose.
3. CAUTION: Do not pry in the caliper sight hole to retract the pistons, as this can damage the pistons and boots.
CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.
Remove the 2 brake caliper guide pin bolts and position the caliper aside.
^
Support the caliper using mechanic's wire.
4. Remove the brake pads from the anchor plate.
5. Remove the 2 brake caliper anchor plate bolts and the brake caliper anchor plate.
^
To install, tighten to 225 Nm (166 ft. lbs).
6. To install, reverse the removal procedure.