E 350 V10-6.8L (2007)
3. Remove the engine air cleaner assembly and the air cleaner outlet tube.
4. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
Disconnect the electronic throttle control electrical connector.
5. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
Disconnect the throttle position (TP) sensor electrical connector.
6. Remove the 4 bolts and the throttle body (TB).
-
Remove and discard the TB gasket.
Installation
1. Install a new TB gasket. Install the TB and bolts. Tighten the bolts in 2 stages.
-
Stage 1: Tighten to 10 Nm (89 lb-in).
-
Stage 2: Tighten an additional 90 degrees.
2. Connect the TP sensor electrical connector.
-
Push back the red clip.
3. Connect the electronic throttle control electrical connector.
-
Push back the red clip.
4. Install the engine air cleaner assembly and the air cleaner outlet tube.
5. Install the engine cover.
6. Connect the battery ground cable.