E 350 V10-6.8L (2007)
5. Install the transmission fluid filter, pan gasket and pan.
6. Connect the solenoid body electrical connector.
^
Tighten to 5 Nm (44 inch lbs.)
Line Pressure Control Solenoid - PC-A
Torqshift Automatic Transmission
Line Pressure Control Solenoid - PC-A
Material
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the transmission main control valve body.
3. Remove the solenoid body electrical connector O-ring seal.
4. Partially remove the solenoid body electrical wire harness.
1
Remove the wire harness-to-solenoid body bolts.
2
Disconnect the electrical connector from the pressure control solenoid (PC-A) and the shift solenoid (SSPC-C)