E 350 V10-6.8L (2007)
2. NOTE: Install the bearing on the coupling shaft with the turned-in lip toward the dust slinger.
NOTE: Install the center bearing bracket with the deep flange facing rearward.
Install the center bearing support on the coupling shaft.
1
Install the rubber insulator in the driveshaft center bearing bracket.
2
Using a suitable press, install the center bearing assembly on the coupling shaft.
3. Install the center bearing retainer.
4. Position the slip-yoke boot clamp on the coupling shaft stub shaft.
5. Slide the small opening end of the slip-yoke boot on the coupling shaft stub shaft, as far as it will travel.