E 350 V10-6.8L VIN S (2006)
Part 2
Removal and Installation
1. Remove the battery.
2. Remove the nut and position the battery ground cable eyelet aside.
-
To install, tighten to 8 Nm (71 lb-in).
3. Remove the nut and position the generator cable and BJB terminals aside.
-
To install, tighten to 9 Nm (80 lb-in).
4. Disconnect the starter solenoid wire in-line connector.
5. Disconnect the 2 harness locators from the frame.
6. Remove the nut and position the battery cable lower bracket aside.
-
To install, tighten to 15 Nm (11 lb-ft) (4.6L), 30 Nm (22 lb-ft) (5.4L, 6.8L) (for vehicles built before 9/2005) or 55 Nm (41 lb-ft) (5.4L,
6.8L)(for vehicles built after 9/2005).
7. Separate the transmission cooler line clip from the battery cable lower bracket.
8. Remove the starter solenoid terminal cover.
9. Remove the nut and position the starter solenoid positive cable aside.
-
To install, tighten to 12 Nm (9 lb-ft).
10. Remove the nut and position the starter solenoid wire terminal aside.
-
To install, tighten to 5 Nm (44 lb-in).
11. Remove the nut and position the battery ground cable terminal aside.
-
To install, tighten to 23 Nm (17 lb-ft).
12. Remove the battery cable assembly.
13. To install, reverse the removal procedure.
