E 350 V8-6.0L DSL Turbo (2007)
Keyless Entry Transmitter: Service and Repair
SLIDING DOOR LATCH REMOTE CONTROL
Special Tool(s)
Special Tool(s)
Removal and Installation
1. If equipped, remove the sliding door trim panel.
2. NOTE: Use the special tool to install the sliding door latch actuator remote control rivet.
If equipped, remove the door lock actuator rivet.
3. Disconnect the exterior door handle attaching rod.
4. Disconnect the door lock cylinder actuating rod.
5. Disconnect the door lock actuator electrical connector.
6. Remove the 3 inner sliding door remote control bolts.
-
To install, tighten to 12 Nm (9 lb-ft).
7. Remove the 3 front sliding door remote control bolts.
-
To install, tighten to 10 Nm (89 lb-in).
8. Disconnect the 2 door latch actuating cables.
9. To install, reverse the removal procedure.
