E 350 V8-6.0L DSL Turbo (2007)
Seat Backrest - Rear, Bench
SEAT BACKREST - REAR, BENCH
Removal and Installation
1. Remove the rear bench seat assembly.
2. Remove the RH detachable safety belt anchor buckle end, if so equipped.
1. Release the cushion trim cover J-clips.
2. Remove the detachable safety belt anchor buckle end bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the detachable safety belt anchor buckle end.
3. Release the J-clip and remove the pin-type retainer at the RH rear of the seat.
4. Remove the LH detachable safety belt anchor buckle end, if so equipped.
1. Release the cushion trim cover J-clips.
2. Remove the detachable safety belt anchor buckle end bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the detachable safety belt anchor buckle end.
5. Release the J-clip and remove the pin-type retainer at the LH rear of the seat.