E 350 V8-6.0L DSL Turbo (2007)
Disassembly and Assembly
1. Remove the rear bench seat assembly.
2. Remove the rear bench seat backrest.
3. If equipped, remove the armrest.
1. Peel back the Velcro(R)-fastened armrest cover to expose the armrest bolt.
2. Remove the bolt and crown washer.
-
To install, tighten to 35 Nm (26 lb-ft).
3. Remove the armrest.
4. Remove the rear seat back cover.
1. Unclip the J-clip at the bottom of the rear seat back cover.
2. Peel the rear seat back cover from the seat back.
5. NOTE: When installing a new rear seat back pad, a cut-out must be made on the new pad to fit around the armrest bracket.
Lift the rear seat back pad from the rear seat back frame.