E 350 V8-6.0L DSL Turbo (2007)
Seat Track: Service and Repair
Seat Track - Front
Seat Track - Front
Removal and Installation
WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow
this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of
serious personal injury or death.
WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in
serious personal injury or death.
NOTE: The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON.
NOTE: The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: Seat tracks and seat motors are only serviceable as a complete seat track assembly.
NOTE: LH shown, RH similar.
All seats
1. Remove the seat. For additional information, refer to Seat Front in this section.
2. Remove the seat backrest. For additional information, refer to Seat Backrest Front in this section.
3. Remove the seat cushion. For additional information, refer to Seat Cushion Front in this section.
Manual seats
4. NOTE: Use the fastener access holes to reach the seat support nuts.
Remove the 4 riser-to-manual seat track nuts.
To install, tighten to 40 Nm (30 lb-ft).
Seats with power
