E 350 V8-6.0L DSL Turbo (2007)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Anti-Lock Brake System (ABS) Module
Removal and Installation
All vehicles
1. Disconnect the battery ground. For additional information, refer to Battery.
2. Remove the 3 bolts and position the degas bottle aside.
^
To install, tighten to 10 Nm (89 inch lbs).
Vehicles equipped with 6.0L engine and Hydro-Boost(R)
3. Remove the air cleaner. For additional information, refer to Fuel Delivery and Air Induction.
All vehicles
4. Remove the 4 screws and position the ABS module to gain access to the electrical connector.
^
To install, tighten to 5 Nm (44 inch lbs).
5. Disconnect the ABS module electrical connector.
^
Release the lock tab.
^
Pull the connector from the module.
Vehicles with standard ABS
6. Lift the ABS module slightly and disconnect the ABS pump motor electrical connector.