E 350 V8-6.0L DSL Turbo (2007)
Vacuum Brake Booster: Service and Repair
Brake Booster - Vacuum
Brake Booster - Vacuum
Removal and Installation
1. With the engine off, apply the brake pedal several times to deplete the brake booster vacuum reserve.
2. Remove the brake master cylinder.
3. Disconnect the brake booster check valve.
4. Disconnect the brake booster push rod.
1
Remove the brake booster push rod cotter pin cover.
2
Remove the brake booster push rod cotter pin.
3
Remove the stoplamp switch.
4
Remove the brake booster push rod bushing.
5
Disconnect the brake booster push rod from the brake pedal pin.
5. Remove the 4 brake booster nuts and the brake booster.
^
To install, tighten to 25 Nm (18 ft. lbs).
6. To install, reverse the removal procedure.
