E 350 V8-6.0L DSL Turbo (2007)
Oil Pressure Sensor: Service and Repair
ENGINE OIL PRESSURE (EOP) SWITCH
Removal and Installation
1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
Turn the ignition switch to the OFF position.
2. Remove the engine cover.
3. NOTE:
-
If there is any oil residue, clean both connecting ports and the inside surface of the charge air cooler tube to prevent the tube from blowing off.
-
Charge air cooler (CAC) side shown, turbocharger side similar.
Loosen the charge air cooler (CAC) tube clamps.
-
To install, tighten to 12 Nm (9 lb-ft).
4. Remove the bolt and position the ground wire aside. Disconnect the electrical connector pushpin.
5. Remove the bolt and position the manifold absolute pressure (MAP) assembly aside.
