E 350 V8-6.0L DSL Turbo (2007)
6. NOTE: Production engines will not have a wear sleeve.
If equipped with a crankshaft wear sleeve, use the special tool to remove the crankshaft rear wear sleeve.
7. Clean and inspect the crankshaft sealing surface.
Installation
1. NOTE: Lubricate the outer diameter of the crankshaft rear seal with a solution of dish soap and water (approximately 50/50 mix) prior to
assembly. Do not use any other type of lubricant.
NOTE: The crankshaft rear seal and wear sleeve are installed as an assembly.
Apply a bead of Threadlock 262 around the circumference of the outer rear edge of the secondary crankshaft flange.
2. Using the special tool, install the crankshaft rear seal.
3. Install the flywheel front adapter.
