E 350 V8-6.0L DSL Turbo (2007)
^
To install, tighten to 9 Nm (80 inch lbs.)
6. Position the power steering reservoir and reservoir bracket aside.
7. Disconnect the coolant hoses from the air cleaner outlet tube.
8. NOTE: Air cleaner side shown, other side similar.
Loosen the 2 clamps and remove the air cleaner outlet tube.
All vehicles
NOTE: The hydraulic booster jumper line and the power steering pressure line can be serviced separately. It is not necessary to disconnect the
jumper line from the hydraulic booster when servicing the power steering pressure line.
9. NOTE: Thoroughly clean all foreign material from the threads.
Disconnect the power steering pressure line-to-hydraulic booster jumper line fitting.
^
To install, tighten to 20 Nm (15 ft. lbs.)
10. NOTE: Thoroughly clean all foreign material from the threads.
Disconnect the power steering pressure line-to-steering gear fitting and remove the pressure line.
^
To install, tighten to 20 Nm (15 ft. lbs.)
11. To install, reverse the removal procedure.
^
Fill the power steering system.
