E 350 V8-6.0L DSL Turbo (2007)
Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION (CKP) SENSOR
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
Turn the ignition switch to the OFF position.
3. Remove the bolt and position the ground cable aside.
-
To install, tighten to 47 Nm (35 lb-ft).
4. Disconnect the crankshaft position (CKP) sensor electrical connector.
5. Remove the bolt, the CKP sensor and discard the O-ring seal.