E 350 V8-6.0L DSL Turbo (2007)
Accelerator Pedal: Service and Repair
ACCELERATOR PEDAL
Removal and Installation
CAUTION: The accelerator pedal and position sensor assembly is a non-adjustable, calibrated unit and must be handled with care.
1. Disconnect the battery ground cable.
2. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
Disconnect the accelerator pedal position sensor electrical connector.
3. Remove the 2 bolts and slide the accelerator pedal and position sensor assembly up and off the anchor bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
4. To install, reverse the removal procedure.
