E 350 V8-6.0L DSL Turbo (2007)
13. NOTE: Cylinder head removed for clarity.
Using the Fuel Injector Sleeve Brush Set, clean the fuel injector bore of deposits and hardened sealant.
14. NOTE: Cylinder head removed for clarity.
Remove the fuel rail plug. Clean the fuel gallery with a wire brush. Use filtered compressed air to remove foreign material from the gallery. Install
the fuel rail plug.
Installation
1. Verify the fuel injector bore is clean and dry.
2. Position the new fuel injector sleeve onto the Fuel Injector Sleeve Installer. Apply threadlock or equivalent to the very bottom (smallest diameter)
and very top (largest diameter) flat areas.
3. Position the Fuel Injector Sleeve Installer into the cylinder head fuel injector bore. Seat the fuel injector sleeve in the fuel injector bore, using a
rubber mallet. If any sealant gets into the inside of the injector sleeve, it must be cleaned out before it hardens.
4. NOTICE: If the fuel injector oil inlet D-shape O-ring is damaged, a new fuel injector must be installed.
Install new O-ring seals and copper washer on the fuel injector. Lubricate the fuel injector and O-ring seals liberally with clean engine oil.
