E 350 V8-6.0L DSL Turbo (2007)
Glow Plug: Service and Repair
Glow Plug Sleeve
GLOW PLUG SLEEVE
Special Tool(s)
Special Tool(s)
Removal
1. NOTE: To install new glow plug sleeves, the cylinder heads must be removed from the vehicle.
Remove the cylinder heads from the engine.
2. Remove the lifting bracket from the cylinder head.
3. NOTE: The glow plug sleeve is made of stainless steel. The glow plug sleeve removal tap must be lubricated. Otherwise, excessive force will be
needed to start the tap, which may result in damage to the tap.
Thread the glow plug sleeve removal tap into the glow plug sleeve.
4. Install the glow plug sleeve removal tool into the threaded sleeve and tighten. Use a wrench to thread the tool into the sleeve until the sleeve is
