E 350 V8-6.0L DSL Turbo (2007)
ABS Sensor Block: Service and Repair
Stability Control Sensor Cluster
Stability Control Sensor Cluster
Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Disconnect the stability control sensor cluster electrical connector.
3. Remove the 2 stability control sensor cluster bolts.
^
To install, tighten to 6 Nm (53 inch lbs).
4. Remove the stability control sensor cluster.
5. To install, reverse the removal procedure.
^
Calibrate the anti-lock brake system (ABS) module. Follow the scan tool directions. Clear the DTCs. Carry out the self-test with the brakes not
applied.
