E 350 V8-6.0L DSL Turbo (2007)
10. Remove the ECT sensor and discard the O-ring seal.
Installation
1. NOTE: Apply clean engine oil to the new O-ring seal prior to installation.
Using a new O-ring seal, install the ECT sensor.
-
Tighten to 18 Nm (13 lb-ft).
2. Connect the ECT sensor electrical connector.
3. Position the CAC pipe and tighten the clamps.
-
Tighten to 12 Nm (9 lb-ft).
4. NOTE: Air cleaner side shown, engine side similar.
Position the air cleaner outlet pipe and tighten the clamps.
5. Connect the coolant hoses to the air cleaner outlet pipe.
