E 350 V8-6.0L DSL Turbo (2007)
20. Disconnect the starter motor electrical harness pushpin, and move the harness to the front of the vehicle.
21. Remove the transmission cooler tubes from the vehicle.
Installation
Diesel engine vehicles
1. Install the fluid cooler tubes, bracket and nut into the vehicle.
^
Tighten to 11 Nm (8 ft. lbs.)
Gas engine vehicles
2. Install the transmission cooler tubes into the vehicle.
3. Reposition the starter motor electrical harness to the rear of the vehicle and connect the pushpin.
4. Connect the starter motor electrical connections.