E 350 V8-6.0L DSL Turbo (2007)
4. Connect the catalyst monitoring sensor harness connectors. Install the harness bracket.
5. NOTE: The output shaft and the driveshaft are a balanced assembly.
Install the driveshaft.
^
Align the index marks and position the driveshaft on the transmission.
^
Position the driveshaft to the rear differential.
6. NOTE: To maintain driveshaft balance, install the driveshaft yoke and flange in the original position that was marked during removal.
Install the 4 driveshaft bolts.
^
Tighten to 103 Nm (76 ft. lbs.).
Manual Control Lever Shaft and Seal
