E 350 V8-6.0L DSL Turbo (2007)
8. Remove the selector lever cable bracket.
^
Remove the bolts.
^
To install, tighten to 28 Nm (21 ft. lbs.)
^
Remove the selector lever cable bracket.
9. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is
snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click into place.
Pull back on the selector lever cable to make sure that it is locked into the bracket. Also, make sure that the selector lever cable end is correctly
installed onto the ball stud. Pull back on the selector lever cable to make sure that the cable end is correctly installed.
To install, reverse the removal procedure.
^
Adjust the selector lever cable.
