E 350 V8-6.0L DSL Turbo (2007)
6. Remove the main control valve body cover plate.
1
Remove the 13 bolts.
2
Remove the valve body cover plate and gasket.
Assembly
1. CAUTION: Before beginning assembly, carry out and inspect these:
When building up subassemblies and assembling the transmission, ALWAYS use new gaskets and seals.
All fasteners must be tightened to the torque specification indicated.
When building up subassemblies, each component part should be lubricated with clean transmission fluid. It is also good practice to
lubricate the subassemblies as they are installed in the case.
Needle bearings, thrust washers and seals should be lightly coated with petroleum jelly during subassembly buildup or transmission
assembly.
Many components and surfaces in the transmission are precision machined. Careful handling during disassembly, cleaning, inspection
and assembly can prevent unnecessary damage to machined surfaces.
Install the main control valve body cover plate.
1
Position the valve body cover plate gasket and cover plate.
2
Loosely install the 2 guide pin bolts.
3
Loosely install the bolts.
