E 350 V8-6.0L DSL Turbo (2007)
5. CAUTION: The driveshaft flange yoke fits tightly on the pinion flange pilot. Never hammer on the driveshaft or any of its components to
disconnect the yoke from the flange. Pry only in the area shown, with a suitable tool, to disconnect the yoke from the flange.
Using a suitable pry bar, disconnect the driveshaft flange yoke from the pinion flange.
6. Lower the driveshaft and slide it off the output shaft.
Installation
1. Inspect the extension housing seal for damage. Install a new seal as necessary.
2. Check to determine if a paint mark is present on the front of the driveshaft and on the end of the transmission output shaft.
3. Lubricate the slip-yoke spline with grease.
