E 350 V8-6.0L DSL Turbo VIN P (2004)
core orifice.
4. If the evaporator core orifice is broken, screw the end of the special tool into the broken orifice. Hold the T-handle stationary while rotating the
tool body to remove the evaporator core orifice.
Installation
NOTE: A new evaporator core orifice should be installed whenever a new A/C compressor is installed. BLACK IS THE REQUIRED TUBE TSB
07-14-11
1. Lubricate the evaporator core orifice O-rings with clean PAG oil and install the evaporator core orifice using the special tool.
2. Connect the evaporator inlet fitting.
-
Install a new O-ring seal.
-
Tighten to 18 Nm (13 lb-ft).
