E 350 1 Ton Van V10-6.8L VIN S (1997)
Power Seat Switch: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
WARNING:
^
THE BELT AND BUCKLE ASSEMBLY PRETENSIONER IS A PYROTECHNIC DEVICE. ALWAYS WEAR SAFETY
GLASSES WHEN SERVICING AN AIR BAG-EQUIPPED VEHICLE AND WHEN HANDLING A BELT AND BUCKLE
ASSEMBLY PRETENSIONER.
^
THE BELT AND BUCKLE ASSEMBLY PRETENSIONER IS A PYROTECHNIC DEVICE. NEVER PROBE THE
CONNECTORS ON THE BELT AND BUCKLE ASSEMBLY PRETENSIONER. DOING SO CAN RESULT IN BELT AND
BUCKLE ASSEMBLY PRETENSIONER OR AIR BAG DEPLOYMENT AND CAN RESULT IN PERSONAL INJURY.
^
TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE INJURY, THE BACKUP POWER SUPPLY MUST BE
DEPLETED BEFORE SERVICING OR REPLACING ANY AIR BAG SYSTEM COMPONENTS. TO DEPLETE THE
BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT ONE MINUTE.
2. Remove the front seat from the vehicle.
1. Remove the plastic bolt covers.
2. Remove the two rear nuts and the two front bolts.
3. Disconnect the belt and buckle assembly pretensioner connector.
4. Remove the front seat.
NOTE: The front seat does not need to be removed in order to remove the seat control switch, but it may be easier to access the wiring connector
and switch fasteners if the seat is removed.
3. Disconnect the power seat control switch connector.
4. Remove the appropriate seat back latch cover to access the switch.
