E 350 1 Ton Van V10-6.8L VIN S (1997)
3. Position the crankshaft rear oil seal and retainer, install the bolts then tighten the rear oil seal retainer bolts and the two oil pan bolts in two stages.
Stage 1: Retainer plate bolts 8-12 Nm (71-107 ft. lbs.)
Stage 2: All pan bolts 14-20 Nm (10-15 ft. lbs.) then rotate 90°
NOTE: If the rear main oil seal is still in place and being reinstalled, be sure the lip is not folded over or wrinkled during the retainer plate
installation. The seal lip must-start squarely on the crankshaft journal.
4. Use the Rear Crankshaft Seal Replacer and Rear Crankshaft Seal Adapter to install the crankshaft rear oil seal.
5. With the Rear Crankshaft Seal Adapter still installed, use the Rear Crankshaft Slinger Replacer and Rear Crankshaft Seal Replacer to install the
crankshaft oil slinger.
6. Install the flywheel.
7. Reconnect the battery ground cable.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control
module relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.