E 350 1 Ton Van V10-6.8L VIN S (1997)
Blower Motor Resistor: Service and Repair
Auxiliary A/C-Heating
REMOVAL
1. Remove the third, fourth, and fifth bench seats as required.
NOTE: This step applies to vehicles equipped with the three-, four-, or five-bench seat option.
2. Remove the trim panels.
a. Remove the left center bolster trim panel.
b. Remove the quarter trim rear upper panel.
c. Remove the lower rear body side trim panel.
NOTE: This step applies to vehicles equipped with the interior trim package.
3. Disconnect the heater blower motor switch resistor connector.
4. Remove the heater blower motor switch resistor.
a. Remove the screws.
b. Remove the heater blower motor switch resistor.
INSTALLATION
1. Follow the removal procedure in reverse order.