E 350 1 Ton Van V10-6.8L VIN S (1997)
9. Pull the seal from the compressor.
INSTALLATION
1. Clean the compressor nose area.
CAUTION: Do not allow dirt or other foreign materials to enter the compressor.
NOTE: Obtain a new A/C Compressor Shaft Seal Kit. Carefully remove the contents of the kit and inspect the plastic shaft seal protector for
burrs or other damage. Do not use if it is damaged.
2. Position the (A) shaft seal on the (B) Shaft Seal Protector.
3. Lubricate the Shaft Seal Protector and shaft seal.
^
Use Motorcraft refrigerant oil YN-12b or equivalent meeting Ford specification WSH-M1C231-B.
4. Position the shaft seal and the shaft seal protector over the compressor shaft.
5. Use the Shaft Seal Replacer to install the seal.
6. Remove the Shaft Seal Replacer and Shaft Seal Protector.