E 350 1 Ton Van V10-6.8L VIN S (1997)
^
Make certain that the CMS wiring harness pushpins are secured in the proper holes in the crossmember and the frame rail. Refer to Figure 6
and 7 for the 138" wheelbase vehicle and Figure 8 for the 158" wheelbase vehicle.
Installation of FTP Transducer
1.
Install FTP transducer (if not previously installed from the assembly plant).
NOTE:
The installed position of the FTP transducer is with the connector pointing toward the rear of the vehicle
^
Clean the top of the fuel tank at the twist-lock plug location.
^
Using an Allen wrench, remove the twist-lock plug by turning it 90 degrees counterclockwise.
^
Remove the plug from the FTP transducer electrical connector.