E 350 1 Ton Van V10-6.8L VIN S (1997)
3. Press at the six, twelve and three o'clock positions to seat the air bag sliding contact.
4. Rotate the wiring and secure into the two wire clips.
5. Connect the two electrical connectors. Snap into the bracket.
6. Install the key-in-ignition warning indicator switch.
7. If a new clockspring is used, remove the yellow anti-rotation tab.
8. Install the ignition switch lock cylinder by turning it to RUN position. Insert the ignition switch lock cylinder into the steering column housing.
Make sure the ignition switch lock cylinder is fully seated and aligned in the interlocking washer before turning the key to the OFF position. This
will permit the retaining pin of the ignition switch lock cylinder to extend into the hole of the steering column.
9. Rotate the ignition switch lock cylinder, using the key, to make sure of correct mechanical operation in all positions.
10. Install the upper and lower steering column shrouds.
11. Install the steering column opening cover.
12. If so equipped, install the tilt wheel handle and shank.
13. Install the steering wheel.
NOTE: Make sure the front wheels are in the straight-ahead position.
14. Install the driver side air bag module.
