E 350 1 Ton Van V10-6.8L VIN S (1997)
3. Install a new bolt with the same part number, unless otherwise specified. Refer to the Parts Replacement Chart in Specifications.
4. Tighten the bolt to specification. Refer to Specifications.
Shoulder Strap Adjuster With Stripped Weld Nuts, Front Seat
1. Remove the shoulder safety belt height adjuster.
2. Drill out the damaged threads in the upper B-pillar structure, using a 1/2-inch drill.
3. Apply a suitable lubricant to the threads of a M14-1.5 tap and tap new threads.
NOTE: After each rotation, back the tap off slightly to remove new cuttings and make sure to blow out any chips.
4. Select Thread Insert N807170-190 and hand-screw it into the tapped hole until it is slightly below the surface of the hole.
5. Using a l2-oz hammer, lightly tap the installation tool several times to drive down the insert "kees".
