E 350 1 Ton Van V10-6.8L VIN S (1997)
Fluid - A/T: Testing and Inspection
Fluid Level Check
CAUTION: If the vehicle has been operating for an extended period at high speeds or in city traffic during hot weather, or pulling a trailer, turn the
vehicle OFF for about 30 minutes to allow the fluid to cool before checking.
Under normal circumstances, you do not need to check the fluid level of the transmission, since the vehicle does not use up transmission fluid. However,
if the transmission is not working properly, for instance, the transmission slips or shifts slowly, or if you notice some sign of fluid leakage, check the
fluid level.
It is preferable to check the transmission fluid level at normal operating temperature after approximately 32 km (20 miles) of driving. However, if
necessary, you can check the fluid level without having to drive 32 km (20 miles) to obtain a normal operating temperature, if outside temperature is
above 10° C (50° F).
With the vehicle on a level surface, start the engine and move the transmission range selector lever through all of the gear ranges, allowing sufficient
time for each position to engage. Securely engage the transmission range selector lever in the PARK position, fully set the parking brake control and
leave the engine running.
Wipe off the fluid level indicator cap, pull the fluid level indicator out and wipe the indicator end clean. Put the fluid level indicator back into the fluid
filler tube and make sure it is fully seated. Pull the fluid level indicator out and read the fluid level.
CAUTION: The vehicle should not be driven if the fluid level is below the COLD marked area on the fluid level indicator and outside temperature is
above 10° C (50° F).
