E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Brake Caliper: Service and Repair
Inspection
For additional information see Installation Notes. See: Fundamentals and Basics
1. Install caliper slide pins through disc brake caliper and front wheel spindle. Tighten bolts to 30-36 Nm (22-26 lb ft).
2. If front brake hose was removed, replace both washers (each side of inlet block). Connect the front brake hose. Tighten inlet block bolt to 14-20
Nm (10-15 lb ft). Perform brake bleeding procedures.
3. Install wheel and tire assembly. Remove the safety stands and lower the vehicle.
4. If the brakes were not bled, and disc brake caliper was not removed check the fluid level in the brake master cylinder reservoir and fill if required.
5. Pump the brakes several times to make sure you get a firm brake pedal.
6. Operate the vehicle to check brake operation.