E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Second Row 3-Passenger Bench Seat
1. Remove the second row 3-passenger bench seat.
2. Place the seat assembly upside down on a clean, protected surface. Refer to illustrations.
3. Choose the desired seating position for the child safety seat (left, center or right hand position). Locate the corresponding tether attachment hole.
The holes are under the upholstery in the rear rail of the seat cushion frame. The J strip (Refer to illustration) must be detached from the rear rail to
release the upholstery and gain access to any of the three (3) holes provided.
4. Refer to Installation procedures.
WARNING: USE ONLY THE TETHER ATTACHMENT HOLE LOCATIONS SHOWN. THE TETHER ANCHORAGE WILL NOT
PERFORM PROPERLY IF THE WRONG MOUNTING LOCATION IS USED.