E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Second Row 3-Passenger Bench Seat
1. Assemble the bolt, tether bracket and nut to the frame rail at the rear of the seat. The tether bracket must be pointing rearward and assembled as
shown.
NOTE: Before installing the tether hardware, read the instructions on the package containing the thread locking material, then open the capsule
and apply thread locking material to all threads on the tether attachment bolt.
2. Tighten the retaining bolt to 22-34 Nm (17-25 lb-ft).
3. Trim the plastic J strip where required and reattach the plastic J strip to the rear rail.
4. Follow the child seat manufacturer's instructions to attach the tether strap to the tether bracket.
WARNING:
-
THE TETHER BRACKET MUST BE BOLTED DIRECTLY TO THE SHEET METAL. THE INTERIOR TRIM MUST NOT BE
TRAPPED BETWEEN THE ANCHOR BRACKET AND THE SHEET METAL. FAILURE TO PROPERLY INSTALL THE
ANCHOR BRACKET COULD RESULT IN IMPROPER ATTACHMENT PERFORMANCE IN THE EVENT OF AN ACCIDENT.
-
THE THREADED HOLE IN THE TETHER ANCHOR OR NUT HAS AN 8 MM METRIC THREAD. A WRENCH WILL BE
NEEDED TO TIGHTEN THE 8MM BOLT TO THE REQUIRED TORQUE. SOME CHILD RESTRAINTS COME WITH A
NON-METRIC BOLT WITH A DIFFERENT THREAD. DO NOT USE A NON-METRIC BOLT AS IT MAY BE IMPOSSIBLE TO
SCREW IT ALL THE WAY INTO THE HOLE, RESULTING IN INADEQUATE RETENTION OF THE CHILD RESTRAINT.
USE ONLY THE METRIC ANCHOR BOLT SUPPLIED IN THIS KIT.
