E 350 Van V8-7.3L DSL Turbo VIN F (1995)
8. If the rear seat shoulder strap opening bezel is damaged, it can be removed from the rear safety belt retractor and tongue by carefully cutting
through the slot located on the back side of the rear seat shoulder strap opening bezel.
-
To prevent damage to the safety belt webbing when cutting through the slot in the rear seat shoulder strap opening bezel, place a smooth, flat,
hard object such as a metal ruler between the webbing and the back side of the belt loop.
9. For installation, follow the removal procedure in reverse order. Tighten all anchor bolts to 30-40 Nm (22-29 lb-ft). Check restraint system for
proper operation.
Seat Belt With Anchor Plate Thread Damage
1. Remove the broken or stripped bolt and discard.
2. Drill out the internal threads in the seat belt anchor plate with a 27/64-inch drill.
3. Rethread the anchor plate with a 1/2-13 tap (seat belt).
4. Blow out the chips.
Parts Replacement Chart
5. Install the attachment parts using the proper service procedures. Refer to applicable illustration. Tighten the replacement bolt to 30-40 Nm (22-29
lb-ft). Original parts are to be replaced with the repair parts indicated in the Parts Replacement Chart. Unless specified in the guides, use original
parts.
6. When repairing a multiple belt and attachment, install nut 382599-5100 to the bolt in the tunnel area from the underside of the floorpan. Tighten to
30-40 Nm (22-29 lb-ft).
Seat Belt Without Anchor Plate Thread Damage
