E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Front Pump Disassembled
1. To disassemble the pump, refer to the Front Pump Assembly image, and remove two seal rings and selective thrust washer.
2. Remove square-cut seal from pump housing outside diameter.
3. Unfasten and remove support from pump housing (5 bolts).
4. Remove drive and driven gear from housing.
5. If pump housing bushing is worn or damaged, it must be replaced.
6. If new bushing is replaced, ensure half moon slot in bushing is on top and in line with oil lube hole.
ASSEMBLE
1. Install drive and driven gears in housing. Each gear has an identification mark on one face. The mark on each gear must be toward front of pump
housing.
2. Position stator support in housing and secure with five bolts.
3. Carefully install two new seal rings in stator support. Ensure ring ends are engaged to lock them in place. Install new square-cut seal on pump
housing outside diameter.
4. Install selective thrust washer of the proper thickness to provide gear train endplay of 0.008-0.044 inch, as measured with the dial indicator prior
to disassembly of transmission.
5. Place pump on converter, making sure that drive gear engages converter hub. Rotate pump to make sure that gears rotate freely.
