E 450 V10-6.8L (2008)
Seat Cover: Service and Repair
Seat Backrest Cover - Front
SEAT BACKREST COVER - FRONT
Removal and Installation
1. NOTE: Install a new crown washer when re-installing the armrest.
Remove the armrest.
1
Release the hook-and-loop at the rear of the armrest trim cover and access the armrest bolt.
2
Remove the armrest bolt and crown washer.
-
To install, tighten to 35 Nm (26 lb-ft).
3
Remove the armrest.
2. Remove the backrest trim cover.
1
Release the J-clip at the bottom of the backrest.
2
CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be
torn from the seat backrest foam pad.
Invert the trim cover up the backrest, separate the hook-and-loop strips and remove the backrest trim cover.
3. To install, reverse the removal procedure.