E 450 V10-6.8L (2008)
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Use a suitable suction device to remove the brake fluid from the brake master cylinder reservoir.
2. Remove the coolant reservoir bolts and position the reservoir aside.
^
To install, tighten to 10 Nm (89 lb-in).
3. Disconnect the speed control deactivator switch electrical connector.
4. Disconnect the brake fluid level switch electrical connector.
5. Disconnect the master cylinder brake tube fittings.
^
To install, tighten to 18 Nm (13 lb-ft).
^
On vehicles with roll stability control (RSC) tighten to 28 Nm (21 lb-ft).
6. Remove the 2 PCM bracket nuts and position the PCM and bracket aside.
^
To install, tighten to 20 Nm (15 lb-ft).
