E 450 V10-6.8L (2008)
Van/wagon vehicles
6. Remove the heat shield bolt.
-
To install, tighten to 18 Nm (13 lb-ft).
7. Remove the lower EVAP canister and bracket assembly bolts and the heat shield.
-
To install, tighten to 18 Nm (13 lb-ft).
All vehicles
8. NOTE: Van/wagon vehicle lower EVAP canister and bracket assembly bolts will already be removed.
Remove the EVAP canister and bracket assembly bolts.
-
To install, tighten to 18 Nm (13 lb-ft).
9. Disconnect the EVAP canister-to-hydrocarbon filter canister tube quick connect coupling from the EVAP canister.
10. Separate and remove the EVAP canister from the bracket.
11. NOTE: Lubricate the O-ring seals with clean engine oil.
To install, reverse the removal procedure.
-
Carry out the evaporative emission system leak test. See: Testing and Inspection
-
Carry out the evaporative emission repair verification drive cycle.