E 450 V10-6.8L (2008)
6.8L Engine
Special Tool(s)
Special Tool(s)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the heated oxygen sensor (HO2S) electrical connector.
3. NOTE: If necessary, lubricate the HO2S with penetrating and lock lubricant to assist in removal.
Using the special tool, remove the HO2S.
-
Apply a light coat of high temperature nickel anti-seize lubricant to the HO2S threads prior to installation.
-
To install, tighten to 46 Nm (34 lb-ft).