ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Safety Belt Retractor - Fifth Row, Outboard|Page 6460 > < Safety Belt Retractor - Fifth Row, Outboard|Page 6458
Page 27
background image

3. If equipped, remove the armrest.

1

Release the armrest trim cover hook-and-loop at the rear edge and partially invert the trim cover to access the armrest bolt.

2

Remove the armrest bolt.
-

To install, tighten to 49 Nm (36 lb-ft).

3

Remove the armrest.

4. Remove the 10 bolts and 2 seat risers.

-

To install, tighten to 51 Nm (38 lb-ft).

5. Release the rear J-clips and partially invert the backrest trim cover.
6. Remove the cardboard panel from the backrest.
7. Release the cushion trim cover rear J-clips and 4 side J-clips.

8. NOTE:  Make sure the safety belt webbing is not twisted prior to installation.

Remove the safety belt anchor bolt and route the safety belt anchor from the seat cushion.
-

To install, tighten to 75 Nm (55 lb-ft).

9. Remove the 4 backrest-to-cushion rear bolts.

-

To install, tighten to 51 Nm (38 lb-ft).

10. Remove the 4 backrest-to-cushion outboard bolts.

-

To install, tighten to 75 Nm (55 lb-ft).

11. Separate the cushion and backrest frames.
12. Release the remaining backrest trim cover J-clips.
13. Remove the 2 screws and safety belt guide cover.
14. Remove the safety belt retractor cover.

15. CAUTION:  Use care not to tear the foam pad when releasing the backrest trim cover retainers.

Invert the backrest trim cover to the row of fasteners, release and separate the trim cover from the foam pad.

16. Invert the trim cover up the backrest and remove.

-

Route out the safety belts.

17. Remove the backrest foam pad.
18. Remove the 2 screws and safety belt guide bracket.

-

To install, tighten to 10 Nm (89 lb-in).

19. Remove the bolt and center safety belt retractor.

-

To install, tighten to 51 Nm (38 lb-ft).

20. To install, reverse the removal procedure.
21. Check the active restraint system for correct operation.

-

Make sure the safety belts and buckles are accessible to the occupants after installation.

-

Verify the safety belt retractor operates without excessive effort or binding.

Safety Belt Retractor - Rear, Center, 4-Passenger Bench Seat

SAFETY BELT RETRACTOR - REAR, CENTER, 4-PASSENGER BENCH SEAT

Exploded View

Safety Belt Retractor - Fifth Row, Outboard|Page 6460 > < Safety Belt Retractor - Fifth Row, Outboard|Page 6458