E 450 V10-6.8L (2008)
8. Lower the transmission onto the insulator and install the bolts.
^
Tighten to 94 Nm (69 lb-ft).
Vehicles equipped with a fixed yoke
9. Using the special tool, install a new output shaft retaining nut.
^
Tighten to 200 Nm (148 lb-ft).
10. If equipped, install the output shaft flange.
1) Install the output shaft flange.
2) Install a new bolt.
^
Tighten to 130 Nm (96 lb-ft).
All vehicles
11. Install the rear driveshaft.
12. Start the engine. Move the selector lever through all the gear ranges, checking for engagements.
13. CAUTION: The use of any other transmission fluid than specified can result in the transmission failing to operate in a normal manner or
transmission failure.
With the vehicle in NEUTRAL, engine running and the transmission at normal operating temperature 66-77° C (150-170° F), check and adjust the
transmission fluid level and check for any leaks. If transmission fluid is needed, add transmission fluid in increments of 0.24L (0.5 pt) until the