E 450 V8-5.4L (2009)
Parking Assist Distance Sensor: Service and Repair
Parking Aid Sensor
NOTE: Standard bumper shown, step bumper similar.
Removal and Installation
NOTE: Right outer parking aid sensors shown, right inner, left outer and left inner similar.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the parking aid sensor electrical connector.
3. Remove the parking aid sensor(s).
-
Press the parking aid sensor retaining tabs to release the sensor(s) from the parking aid sensor bezel.
4. To install, reverse the removal procedure.
-
Using the scan tool, verify that the parking aid sensor distance PIDs read no object present, and that the parking aid sensor attenuation PIDs
read between 0.8-1.6 ms.
5. Carry out the azimuth and elevation test. For additional information, refer to Azimuth System Check See: Testing and Inspection/Component
Tests and General Diagnostics/Azimuth System Check and Elevation System Check See: Testing and Inspection/Component Tests and General
Diagnostics/Elevation System Check