E 450 V8-5.4L (2009)
1. Turn the ignition to OFF.
2. Remove the engine cover.
3. Disconnect the telematics module electrical connector.
4. Remove the 2 screws and the telematics module.
Installation
1. Position the telematics module and install the 2 screws.
-
Connect the electrical connector.
2. Install the engine cover.
3. Initialize the telematics module.
1. Wait 5 minutes after the modem-antenna is installed.
2. Turn the ignition to RUN.
3. Wait 10 seconds.
4. Start the vehicle and run the engine for 30 seconds.
5. Turn the ignition to OFF.
Tool Link(TM) Reader
Tool Link(TM) Reader
Removal and Installation
1. NOTE: Support the Tool Link(TM) reader while the 2 screws are being removed. Do not allow it to hang from the electrical connectors.
Remove the 2 screws and the Tool Link(TM) reader.
-
Disconnect the electrical connectors.
-
If the Tool Link(TM) reader is being replaced, cut the power/ground feed from the vehicle electrical harness.
