E 450 V8-5.4L (2009)
If no DTCs returned, the TBC module and vehicle wiring are operating correctly. SEND the trailer to an authorized camper/trailer repair center.
CLEAR the DTCs. REPEAT the self-test.
-------------------------------------------------
C4 CHECK THE TBC MODULE PWM OUTPUT CIRCUIT FOR A SHORT TO GROUND
-
Ignition OFF.
-
Disconnect: TBC Module C2142.
-
Measure the resistance between 7-pin trailer tow connector pin-3, circuit CAT19 (BU), harness side and ground.
-
Is the resistance greater than 10,000 ohms?
Yes
GO to C7.
No
REPAIR circuit CAT19 (BU). CLEAR the DTCs. REPEAT the self-test.
-------------------------------------------------
C5 CHECK THE TBC MODULE OUTPUT
NOTE: Every 4 seconds a voltage pulse is applied as a trailer connectivity test.
-
Make sure the brake pedal is not pressed and the manual slider switch is not being applied.
-
Measure the voltage between 7-pin trailer tow connector pin-3, circuit CAT19 (BU), harness side and ground.
-
Is the voltage approximately 0.3-0.5 volt?
Yes
GO to C7.
No
GO to C6.
-------------------------------------------------
C6 CHECK THE TBC MODULE PWM OUTPUT CIRCUIT FOR A SHORT TO VOLTAGE
-
Ignition OFF.
-
Disconnect: TBC Module C2142.
-
Ignition ON.
-
Measure the voltage between 7-pin trailer tow connector pin-3, circuit CAT19 (BU), harness side and ground.
-
Measure the voltage between 7-pin trailer tow connector pin-3, circuit CAT19 (BU), harness side and ground while operating the following lamps